← See the full germination data sheet

How to germinate Amorphophallus titanum — step-by-step guide

Titan arum
By Caio Molon Nogueira, especialista em espécies exóticas

Amorphophallus titanum, the titan arum, is difficult from seed. Its seeds are recalcitrant: they cannot be dried or stored and must be cleaned of fruit flesh and sown immediately. They also need tropical warmth and high humidity. Germination can take from 30 to 180 days, and the seedling first forms a small corm. Expect a long, steady effort.

Before you start: don't use all your seeds at once

Even though these seeds should be sown fresh, split them into small batches and sow only one batch first, for example half. Keep the rest wrapped in slightly damp (not wet) moss or paper in a closed container in a cool, dark place, and sow them soon after. Label each batch with the date and what you did. If the first batch fails, you'll still have seeds to try again.

Quick summary

Step What to do Time
1 Remove all fruit flesh 15 minutes
2 Sow 1 cm deep in airy aroid mix 15 minutes
3 Keep at 24–30°C (ideal 27°C), very humid 30–180 days
4 Care for the young corm Ongoing
5 Pot on carefully When the plant grows

What you'll need

  • Gloves and a paper towel for cleaning
  • Rich, airy aroid mix (bark, peat, perlite)
  • Deep pots with drainage holes
  • A clear cover, bag or propagator to keep humidity high
  • A heat mat or a warm spot (24–30°C)
  • Labels

Step 1 — Clean the seeds

Remove all the fruit flesh by rubbing gently with a paper towel or under running water. Do this right before sowing.

Why? The flesh rots and spreads fungus. Clean seeds are much less likely to go mouldy.

Step 2 — Sow immediately

Fill deep pots with a rich, airy aroid mix of bark, peat and perlite, moisten it, and sow the seeds 1 cm deep.

Why immediately? Recalcitrant seeds die if they dry out. Every day of delay lowers the chances.

Step 3 — Keep warm and humid

Cover the pots to keep humidity high and place them where the temperature stays between 24°C and 30°C, ideally around 27°C. Light is not critical. Keep the mix moist (high moisture), but never waterlogged. Check weekly for mould and ventilate briefly. Germination can take 30 to 180 days.

Step 4 — Care for the young corm

The seedling first forms a small corm and a single leaf. Keep it warm, humid and in bright, indirect light. If the leaf dies back and the plant goes dormant, reduce watering and never let the corm sit waterlogged.

Step 5 — Pot on

When the leaf grows larger, move the plant to a slightly bigger deep pot, handling it by the corm area carefully and never pulling on the leaf stalk.

If your seeds don't germinate

  • Germination can take up to 180 days; keep conditions steady and don't empty the pots early.
  • If the temperature fell below 24°C, move the pots somewhere warmer or use a heat mat.
  • If seeds turned soft and mushy, they rotted: improve drainage and air flow for the next batch.

Common mistakes

  • Letting the seeds dry out before sowing
  • Leaving fruit flesh on the seeds
  • Germinating in a cool room
  • Overwatering a dormant corm
  • Disturbing the pot to check for roots

Need help?

Contact Quinta dos Ouriques and send a photo of your seeds or pots, with your sowing date and the temperature. We'll help you work out what to do next.

Quinta dos Ouriques · university.quintadosouriques.com/how-to-germinate/amorphophallus-titanum-step-by-step